Binding The Controller To The Valve Actuator - Caleffi 210 Serie Anleitung Für Installationund Inbetriebnahme

Binding the controller to the valve actuator

Note: The actuator must be installed on the radiator before binding it to the controller.
THU THU
LIVING ROOM LIVING ROOM
24/04/14 24/04/14
TEMPERA TEMPERATURE SENSOR EMPERA A TURE SENSOR
WINDOW SENSOR WINDOW SENSOR
ACTUA A TOR ACTUATOR
DEVICE YOU WANT TO ADD DEVICE YOU W DEVICE YOU WANT TO ADD
THU
LIVING ROOM
24/04/14
TOUCH A BUTTON OF THE ACTUATOR
FOR 2 SECONDS WITHIN 2 MINUTES
THU THU
RADIATOR RADIA A TOR
24/04/14 24/04/14
ALUMINIUM ALUMINIUM
CAST IRON / STEEL CAST IRON / STEEL CAST IRON / STEEL
SELECT OPTION SELECT OPTION
Note: In order to easily identify the actuators and their position, it is advisable to use the space provided in
the section ACTuATOR INSTALLATION DIAGRAM at the end of this manual. This will make some operations
easier, such as identifying actuators with flat batteries (an identification number is assigned to each actuator,
e.g. VALVE 1).
14:48 14:48
TURE SENSOR
TOR
14:48
TOR
14:48 14:48
1.
Select VALVE ACTuATOR from the ADD menu.
1a.
Press any button to start the binding procedure.
2.
Hold down any button on the actuator for 2 seconds
within 2 minutes. You can use any one of the four
buttons on the top part of the
actuator.
The on-board red LED blinks
from 2 to 4 times to indicate
the correct binding
3.
Select the type of radiator on which the actuator was
installed in order to improve temperature regulation.
15