Safety - Caleffi 210 Serie Anleitung Für Installationund Inbetriebnahme

Warnings
These instructions must be read and understood before installing and performing maintenance on the device. The symbol
means: CAUTION! FAILURE TO FOLLOW THESE INSTRUCTIONS COULd RESULT IN A SAFETY HAZARd!

Safety

CAUTION! YOUR SAFETY IS INVOLVED. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN DANGER
THE PRODUCT SUPPLIED WITH THIS INSTRUCTION SHEET IS C LLED "DEVICE"
1 The device must be installed, commissioned and maintained by licensed technicians in accordance with national regulations and/or
the relevant local requirements.
2 If the device is not installed, commissioned and maintained correctly in accordance with the instructions provided in this manual, it
may not work properly and may endanger the user.
3 The device is not intended to be used by people (children included) with reduced mental, physical and sensory faculties or with lack
of experience unless they are supervised or instructed in the use of the device by a person responsible for their safety.
4 Any use of the device other than its intended use is prohibited.
5 The device is not suitable for use in agricultural applications.
6 Any coupling of the device with other system components must be made while taking the operational characteristics of both units
into consideration. An incorrect coupling could compromise the operation of the device and/or system.
1 CAUTION: Risk of electric shock. Live parts.
Cut off the electric supply before opening the device box.
2 Wiring must be made according to the state of the art and, in case of connection to the electric network, the minimum cross-section
of the cable must be equal to 0,75 mm
3 During installation and maintenance procedures, always take care to avoid direct contact with live or potentially hazardous parts.
4 The device must be installed in a specific area and must not be exposed to leakages or humidity, direct sunlight, bad weather,
sources of heat or high-intensity electromagnetic fields. This device cannot be used in areas at risk of explosion or fire.
5 The device must have a separate connection to an independent bipolar switch. If the equipment needs maintenance, cut off the
electric supply before any work is carried out Do not use devices with automatic or timed reset, or which may be reset accidentally.
6 Use suitable automatic protection devices in accordance with the electrical characteristics of the zone in which the device is installed
and in compliance with current legislation.
7 The device must always be earthed before it is connected to the electric supply. If the device needs to be removed, the earth connection
should always be disconnected after the other electrical wires. Make sure that the building has been earthed professionally, in
accordance with current legislation.
dISPOSE OF THE PROdUCT IN COMPLIANCE WITH CURRENT LEGISLATION
.
2
LEAvE THIS MANUAL AS A REFERENCE GUIdE FOR THE USER.
2