Inhaltsverzeichnis; Introduction To Use; Symbols Placed In Correspondance With Usage Points - Femi 785 XL Gebrauchsanleitung Und Wartung

INDEX
1 INTRODUCTION TO USE ....................................... 9
2 INSTALLATION ..................................................... 11
3 ADJUSTING (Fig. 4-5-6-7-8) ................................. 12
4 USE ....................................................................... 12
5 ACCESSORIES ..................................................... 14
6 MAINTENANCE ..................................................... 14
7 TROUBLESHOOTING ........................................... 15
1

INTRODUCTION TO USE

Before starting work with your sawing machine, carefully
read this instructions manual so that you are familiar with
the machine and its uses and where it should not be used.
Keep this manual in a safe place. It is an integral part of the
machine and should be used for reference in operating the
machine correctly and in the proper safety conditions.
Use the machine only and exclusively for the uses specifi ed
below, as recommended in this manual. The machine should
not in any way be tampered with, or forced, or used for
unsuitable purposes.
1.1 SYMBOLS PLACED IN CORRESPONDANCE
WITH USAGE POINTS
Never underestimate the warnings "ATTENTION - CAUTION"
given in this manual.
In order to draw the user's attention and to preserve safety,
hazardous operation are preceded by symbols and notes that
point out the danger and explain how to behave to avoid any
risk. These symbols and notes are divided in three categories,
identifi ed by the following words:
ATTENTION: dangerous-behaviours that could cause
serious injuries.
CAUTION: behaviours that could cause slight injuries
or damages to things.
NOTE: the notes preceded by this symbols are
technical and are aimed at making operations
easier.
1.2 SAFETY AND RULES
The machine was designed and built according to the
Community Directives in force: EC/2006/42 - EC/2006/95-
EC/2004/108.
The enclosed CE Declaration of conformity, togheter with the
CE mark on product, essentially comprise and are an integral
part of the machine : both guarantee product conformity with
the aforesaid safety Directives.
1.3 SAFETY PLATES/LABELS
The safety plates/labels and indicators present on the
machine, the location of which is shown in the Figure 12,
are as follows:
- Wear noise protection devices.
- Wear safety masks or goggles.
- Do not insert the hands in this area with the
tool operating. Danger of dragging/cutting.
Fig. 12
1.4 RECOMMENDED AND NOT RECOMMENDED
USAGE
This belt sawing machine was designed and constructed
according to the most advanced technologies and may be
used for all cutting requirements for metals commonly used
in industry and artisanship.
It can cut:
- COMMON STEELS (FE 37...)
- SPECIAL STEELS (C 40, 18NiCrMo5...)
- ALUMINIUM AND ITS ALLOYS
- BRASS
- BRONZE
- STEEL TUBING (FE 35, FE 52...)
- PROFILED SECTIONS IN SHEET METAL AND
ALUMINIUM
It is not suitable for cutting:
- WOOD AND SIMILAR MATERIALS
- BONE AND SIMILAR MATERIALS
BENCHTOP BAND SAW
ATTENTION: The band saw has been developed
and manufactured to cut in dry condition; the
use of any cooler by lubricating oil makes the
machine unusable.
Matr. n. ...........
9