Quick Reference - Megasat Countryman-GPS Benutzerhandbuch

2. Operating instruction
D Changing the satellite
Function Description
"Satellite Up/Down
button" Light
"OK" Button
E Back to Home position
Function Description
"HOME" Button
F GPS LED light
Function Description
„GPS" light
ENGLISH
08
Operation
If you want to change desired satellite, you can change the
target satellite using the "Up/Down" buttons, then press
the "OK" button to select the new satellite.
Operation
Whenever you wish to return the antenna back to the
Home position, press and hold the"Home" button for a few
seconds.
Operation
GPS LED confirms the current location from 24 GPS satelli-
tes in the world.
When your Countryman GPS identifies a GPS signal, GPS
LED light will
remain on, regardless if the antenna is pausing or moving.
GPS can help to search for the satellite faster & catch the
optimum satellite signal, and assist Countryman GPS to
acheive the
best elevation & skew angle.
Also, while program updating, the GPS LED light will flash
to show the update procedure is processing. During this
time, GPS LED light on doesn't mean the unit is communi-
cating with GPS satellite.
2. Operating instruction

Quick Reference

Classification Description
1. Take out the antenna from carrying case, and place it on the flat ground (or mount
it on the top of the camper) facing South & no obstacle.
2. Connect the left port of the antenna, which located at the rear of the main unit, to
the controller using controller cable.
a) One end of the controller cable connect to „controller" port of the main unit of
Setting the antenna.
& b) The other end of the controller cable connect to the port of the controller.
Connecting 3. Connect the power cable to controller.
a) If you use the power source from a car or caravan etc, use the cigarette lighter
adaptor to connect the power to controller.
b) Otherwise use a suitable 12 Volt DC adaptor to connect the power to controller.
4. Connect between the right port of the antenna, which located at the rear of the
main unit, to the receiver using receiver cable.
1. Switch on with the "Power switch" button on the top of the controller.
2. Upon power on, all LED will flash twice.
3. Wait until "HOME State" light & one "Satellite LED" light, which you set previously or
Operating the first satellite in the controller (Turksat), remain solid on.
(Searching the 4. Select the desired satellite using the "UP/DOWN" buttons, then press the "OK"
satellite) button to select.
5. The satellite LED light will start to flash, wait until it stays solid on.
6. When the satellite LED light stays solid on, the selceted satellite has been located
and a signal can be seen on the satellite TV.
When you move Countryman GPS, the flat dish of the
antenna must be be in the Home position.
Note
Car Mounting Instruction will be provided separately.
Note
Countryman GPS will be automatically folded back to HOME position if the
vehicle moves faster than 10km/h, when the reception of GPS is stable.
Note
Purchase Power Adapter separately from us, or if you purchase it on your
own, purchase ONLY 18V / 3.3A which is certified.
ENGLISH
09