Hilti GX 2 Bedienungsanleitung Seite 28

Malfunction
Fasteners break.
Fasteners bend.
Fasteners do not hold in steel
base material.
The content of the gas can is
inadequate for the number of
fasteners in the package.
The fastener guide hasn't
fully extended after driving
a fastener.
Fastener driving failure rate is
too high.
24 English
Printed: 03.03.2017 | Doc-Nr: PUB / 5336064 / 000 / 00
Possible cause
Driving power is too low.
The fasteners are too long.
The supporting material is too
hard.
The fastener guide is not held per-
pendicular to the working surface.
Driving power is too low.
The fasteners are too long.
The fastener guide is not held per-
pendicular to the working surface.
The supporting material is too thin.
High gas consumption due to fre-
quent compression of the tool
nosepiece without driving a fas-
tener.
A fastener has jammed in the fas-
tener guide.
The fastener guide is not held per-
pendicular to the working surface.
Action to be taken
▶ Move the fastener driving depth
adjustment slider to the +
position.
▶ Use shorter fasteners.
▶ Consider using a DX fastening
tool.
▶ Use the support leg on an even
surface and make sure that it's
in contact with the surface (see
support leg → page 18).
▶ Press the nose of the tool
against the working surface,
keeping the fastener guide
perpendicular to the surface
(see driving nails, → page 20).
▶ Move the fastener driving depth
adjustment slider to the +
position.
▶ Use shorter fasteners.
▶ Use the support leg on an even
surface and make sure that it's
in contact with the surface (see
support leg → page 18).
▶ Press the nose of the tool
against the working surface,
keeping the fastener guide
perpendicular to the surface
(see driving nails, → page 20).
▶ Use a different fastening
method.
▶ Avoid compressing the tool
nosepiece without driving a
fastener.
▶ Remove the fastener guide
→ page 22.
▶ Release the jammed fastener.
▶ Clean the fastener guide.
▶ Remove foreign objects from
the area of the fastener guide.
▶ Use the support leg on an even
surface and make sure that it's
in contact with the surface (see
support leg → page 18).
▶ Press the nose of the tool
against the working surface,
keeping the fastener guide
perpendicular to the surface
(see driving nails, → page 20).