Ingersoll-Rand 293 Series Technische Produktdaten Seite 4

EN
Power Adjustment in the Forward Direction
1. While facing the back of the Impactool, push the Reverse Lever to the extreme right
position.
2. Using a screwdriver, rotate the Power Regulator so that the slot aligns with the desired
power calibration.
3. The power of the tool is now adjusted for the forward direction but will still have full
power in the reverse direction. This adjustment will not change regardless of how many
times you shift the Reverse Lever as long as you do not change the power selection.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily.
Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device
across any hose coupling without internal shut-off, to prevent hose whipping if a hose fails
or coupling disconnects. See drawing 04581666 and table on page 2. Maintenance
frequency is shown in circular arrow and defined as h=hours, d=days, and m=months.
Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
16581951_ed2