Brink E-module Bedienungsanleitung Seite 6

Activating the interface module
UK
1. Installing and mounting E-module / I-module.
2. Connecting E-module / I-module interface directly to a PC/laptop using a network cable.
3. Connecting the power supply and the eBus link.
4. Go from PC/ laptop to the
5. Select "
6. Right-click the network link that connects the E-module/I-module interface and select "
7. Select "
8. Remark: It is necessary to overwrite existing settings.
9. Select "Use the following IP address".
10. Enter 192.168.1.68 at "IP address".
11. Enter 255.255.255.0 at "
13. Click OK
14. Click "
15. Static IP address of the E-module / I module is activated by pressing and holding during 1-5 s the button on the E-module/I-
module (until the green LED lights up).
16. The control panel of the E-module / I-module is called up through an internet browser by entering the static IP address 192.168.1.67
in the browser command window (make sure the browser version is compatible).
17. Click " ".
19. "
20. If internet access is desired to the portal, tick, "
21. Change password E-module / I-module as required (write down username and password!)
For LAN operation of the E-module / I-module:
23. Restore the original network settings of the PC / laptop (repeat items 4-7).
24. Connect the interface module to the router through a LAN (network cable).
25. Switch off the ventilation appliance and take the power supply from the E-module. Reconnect the power supply to the E-module.
the green LED is continuously on when the internet connection is allowed.
6
and then to
" in the menu bar.
" and then click "
".
", " " and "
Password: 1111
" must be switched on.
I-module/ E-module
".
".
remain empty.
".
Art.-nr.: 614382-A