Sony BDX-N1000 Bedienungsanleitung Seite 13

WARNING
To prevent fire or shock hazard, do not expose the unit to
rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
For the customers in the USA
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
The shielded interface cable recommended in this manual
must be used with this equipment in order to comply with the
limits for a digital device pursuant to Subpart B of Part 15 of
FCC Rules.
This symbol is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Caution (for BDKP-N1002 only)
This Network Adapter Board is classified as a CLASS 1
LASER PRODUCT.
The CLASS 1 LASER PRODUCT label is located on the rear
panel.
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
CAUTION
The use of optical instruments with this product will increase
eye hazard.
WARNING: THIS WARNING IS APPLICABLE FOR USA
ONLY.
If used in USA, use the UL LISTED power cord specified
below.
DO NOT USE ANY OTHER POWER CORD.
Plug Cap Parallel blade with ground pin
(NEMA 5-15P Configuration)
Cord Type SJT, three 16 or 18 AWG wires
Length Less than 2.5 m (8 ft. 3in.)
Rating Minimum 10 A, 125 V
Using this unit at a voltage other than 120V may require the
use of a different line cord or attachment plug, or both. To
reduce the risk of fire or electric shock, refer servicing to
qualified service personnel.
Laser Diode Properties
Material: InGaAsP
Wave length: 1300 nm
Emission duration: Continuous
Laser output power: 0.16 mW
Laserdiode data
Materiale: InGaAsP
Bølgelængde: 1300 nm
Strålingsvarighed: Kontinuerlig
Lasereffekt: 0,16 mW
Laserdiodens egenskaper
Material: InGaAsP
Våglängd: 1300 nm
Strålningstid: utan avbrott
Laseruteffekt: 0,16 mW
Laserdiodens egenskaper
Materiale: InGaAsP
Bølgelengde: 1300 nm
Emisjonslengde: Kontinuerlig
Laser utgangseffekt: 0,16 mW
1 (E)