Fc1 Ex (Hs) - Commissioning - Funktel FC1 Bedienungsanleitung

FC1 Ex (HS) – Commissioning
Inserting the MEM card into the FC1 Ex
Inserting the MEM card is as for the Business Handset FC1. See page 47.
Inserting the battery into the FC1 Ex
Caution: Observe the safety instructions for changing the battery of an
explosion-proof handset on page 77/79!
GB
• Push the battery into the housing (1).
• Push the battery down on the screw side until it makes contact with the
housing (2).
• Fix battery with the securing screw (2). Use a screw driver Torx T 10.
The maximum fastening torque of the screw is 60 Ncm. We recomend to
use the screw driver with the part number 50 1010 5300. This screw
driver is also available as a set of five using the part number
50 1010 5400.
Installing the charger FC1 S Ex, part no. 50 1018 1001
(only outside of hazardous areas)
Place the charger on a firm, level surface, e.g. a table. Select a location
outside of hazardous areas which is protected against direct solar
radiation and wetness.
• Plug the plug-in power supply unit into a socket outlet.
• Plug the small connector of the connecting cable into the socket on the
back side of the charger. Note: The Business Handset FC 1 and the
Handset FC 1 Ex are different regarding their housing dimensions and
therefore have different chargers.
The charger is now ready for operation.
80
Messaging on Mobility Server I 33 / CS I55
V 3.5 • 05/2005