Messaging - Funktel FC1 Bedienungsanleitung

Messaging on Mobility Server I 33 / CS I55

Messaging

1
Messaging enables you to send and receive brief messages with your
business handset.
You may send messages to individual subscribers and to groups. The call
number of a subscriber may vary from his telephone number in some
cases.
The messages are defined texts (fixed texts). The subsequent dialling of
any digits (figures) is permissible as needed. The list of fixed texts can be
obtained from your system administrator.
Verification for the sending party of the message:
The sender receives confirmation of the successful transmission of the
message, and of acknowledgement of receipt of the message by the
receiver, should this occur.
The latest 10 messages are stored in the message list. You may call back
the sender directly from the list.
Note:
During reception of a message and during a possibly required manual
acknowledgement, an existing call connection is continued. Your
telephone partner can hear the signalling of the message.
Example:
User A and user B are holding a telephone conversation. User A receives a
message, announced by an acoustical signal.
The telephone connection persists during reception of the message and
during a possible manual acknowledgement from user A. The handset
microphone of user A remains switched on so that user B can hear what
happens at the site of user A.
The conversation can be continued after signalling and acknowledgement
are complete.
1
The messaging functions are available only on Mobility Server I 33 /
CS I55 with an additional Message Server connected.
The Message Server is a supplement to your private telephone system.
Refer to the header which contains the type of Mobility Server needed
for the functions described below.
V 3.5 • 05/2005
GB
65