CONGA Cecotec 1090 Bedienungsanleitung Seite 17

ENGLISH
Fig. 18
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to
prevent product damage and ensure safe operation.
Fig. 19
Direct exposure to sun light or great light constrasts may affect to the correct operating of the
sensors. If this happens and the robot stops, change it to a new location for it to start operating
again.
1. Place the charging base against the wall and leave a minimum free space of:
2 metres to the front.
1 metre to each side.
Fig. 20
2. Connect the charging base to a power supply. Wind and store the remaining cord in the lower
part of the charging base to avoid accidents.
Fig. 21
3. Install both side brushes in their corresponding slots, located on the robot's bottom part.
Press until it clicks to make sure they are properly fixed.
Fig. 22
4. Press the power switch located on the bottom part of the robot. Make sure the power switch
in ON.
Fig. 23
5. Place the robot on the charging base and make sure the charging terminals on the robot
match with those of the charging base. Once the robot is properly placed, it will beep once
and the power button will light up. If the light blinks orange, the battery is not completely
charged. To ensure maximum cleaning time, wait until the light switches to steady blue. This
will indicate the battery is fully charged and that the robot is ready to clean.
Fig. 24
4. OPERATION
Start cleaning
Long press the power button on the robot to start the robot up.
Press the power button on the robot or on the remote control to start cleaning.
Note: if the robot runs out of battery during cleaning, it will automatically return to the charging
32
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
WARNING: if there is no good access to the charging, the robot will not be able to return to its
charging position. In that case, once the robot has stopped, take it manually to the charging
base.
Pause
Press the power button on the robot or on the remote control to pause the cleaning process.
Press the power button on the robot or on the remote control to resume the cleaning process.
Fig. 25
Return to the charging base
Press back-home button on the robot or on the remote control for the robot to return to the
charging base.
Turn off
Long press the power button to turn the robot off.
Fig. 26
WARNING: the robot vacuum cleaner has a power switch located on its main body. If the robot
is not going to be used for long periods of time, it is suggested to switch it off. If the robot is
switched off, it will restore factory default settings as a safety measure. The robot will only
carry out scheduled cleaning if it has been scheduled while the switch is ON, otherwise, it will
have to be scheduled again from the remote control or the App.
Cleaning modes
This robot includes different modes and different functions that can be activated from the
remote control or the App.
The App is only compatible with Conga 1090 Connected, Conga 1090 Connected Force and
Conga 1099 Connected.
1. Auto cleaning mode
Press button for the robot to start auto cleaning mode.
The robot will clean the whole surface, edges, around objects such as tables, chairs etc. until it
starts running out of battery and therefore returns to the charging base.
Fig. 27
2. Scrubbing mode
Attach the mop cloth to the water tank and fill the tank with water.
Remove the dust tank.
Install the water tank in the robot and turn it on.
Fig. 28
Use the remote control to select the desired scrubbing power level: high, medium or low.
CONGA 1090 CONNECTED/ 1090 CONNECTED FORCE/ 1099 CONNECTED
ENGLISH
33