Safety Instructions; Parts And Components - CONGA Cecotec 1090 Bedienungsanleitung

ENGLISH

1. SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
This product must be used in accordance with the directions
in this instruction manual. Cecotec cannot be held liable or
responsible for any damages or injuries caused by improper
use.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the wall outlet is
grounded.
This product can only be disassembled by qualified personnel.
Do not touch wires, power supplies or power adapters with
wet hands.
Keep the robot away from clothing, curtains and any other
similar materials.
Do not expose the robot to direct sun, open fire or wet
environments.
Do not sit or place heavy or sharp objects on top of the appliance.
This product is designed for indoor use only, do not use
outdoors.
Before operating the robot, remove all objects and wires that
could affect its operating.
Always place the device on a flat and stable surface. Avoid
placing it in unstable places where there is risk of falling, such
as tables or chairs.
Turn off the power switch, located on the bottom part of the
robot, when it is not going to be used for a long time.
Before operating it, make sure all the robot's and charging
base's connections are in good conditions.
Avoid operating the product under extremely high or low
temperatures.
Remove the battery from the product's inside before scrapping
28
the robot.
Disconnect the appliance from the power supply before
removing the battery.
The appliance is not intended to be used by children under the
age of 8. It can be used by children over the age of 8, as long as
they are given continuous supervision.
This appliance can be used by children aged 8 and above, and
persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge, as long as they have
been given supervision or instruction concerning the use of the
appliance in a safe way and understand the hazards involved.
Supervise young children to make sure that they do not play
with the appliance. Close supervision is necessary when the
appliance is being used by or near children.

2. PARTS AND COMPONENTS

Wi-Fi connection light indicator (only in 1090 Connected, 1099 Connected and 1090 Connected
Force)
Fig. 1
1. Back-home button
2. Light indicator
3. Power/operation button
Back-home button
The robot will automatically go to the charging base when this button is pressed on the robot
or on the remote control.
Light indicator
Steady orange light: low battery.
Blinking orange light: charging.
Steady blue light: fully charged/standby mode/cleaning.
Blinking red light: error
Power/operation button
Long press this button for a few seconds to turn the robot on or off.
CONGA 1090 CONNECTED/ 1090 CONNECTED FORCE/ 1099 CONNECTED
ENGLISH
29