Adding Extra Water; Emptying The Pod Basket; Emptying The Drip Tray; Setting The Water Hardness - AVOURY ONE Bedienungsanleitung

USE
EN
PAGE 32

Adding extra water

If there is not enough water in the water
tank to complete another brewing
4
process, the "Water tank empty" LED
will be illuminated. You cannot carry out
any more brewing processes until you
have re lled the water tank.
1. Remove the water tank and ll with
water up to a maximum level of two
nger widths below the upper edge
of the water tank.
2. Replace the water tank again.
The "Water tank empty" LED will go
out.
If the water level is too low, you
should add fresh water before
the "Water tank empty" LED
lights up.
Emptying the pod bas-
ket
After six brewing processes, the "Empty
pod basket" LED will be illuminated
11
and the pod basket must be emptied.
Otherwise, no further brewing process-
es can be carried out.
1. Remove the pod catching drawer
from the tea maker and take out the
pod basket.
2. Dispose of the used pods.
3. Place the pod basket and the pod
catching drawer back into the tea
maker.
The "Empty pod basket" LED will go out
and the tea maker is ready to use again.

Emptying the drip tray

10
1. Remove the pod catching drawer
from the tea maker and empty the
pod basket.
2. Remove the drip catcher
3. Empty the drip tray.
4. Then replace all the parts in the tea
maker.
Setting the water
hardness
1. Switch on the tea maker.
7
2. Press the buttons for setting the
brewing time +/–
neously.
The display
shows the level of water hardness
currently set.
7
.
6
/ simulta-
14 15
on the tea maker
16
PAG E 13