Cancelling The Tea Preparation Process; Switching Off The Tea Maker - AVOURY ONE Bedienungsanleitung

USE
PAG E 12
7. Close the pod compartment again.
The tea maker will automatically
read the preparation parameters
provided by the pod.
8. If necessary, use the –/+
buttons for the lling capacity to set
the desired quantity of water. Select
a lower quantity of water for strong-
er tea and a higher quantity of water
for weaker tea. Each press increases
or decreases the water quantity by
15 ml (max. 210 ml, min. 150 ml). The
standard cup size is 180 ml.
9. If necessary, use the +/–
brewing time buttons to set the
desired brewing time for the tea.
Select a longer brewing time for
stronger tea and a shorter brewing
time for weaker tea. The brewing
time will increase or decrease by
one minute with each press.
10. Press the On/O button to brew
the tea.
The LEDs on the lling capacity
display will switch o one after
17
another until the tea has been dis-
pensed in full.
The brewing time display
shows the remaining brewing time.
After the brewing process, the pod
will be ejected automatically and
the brewing container will be rinsed
to prevent any aroma mixing and
to ensure that you can enjoy the
avours of each type of tea. The
rinsing water runs into the drip tray
and not into the cup.
11. To prepare another cup, open the
pod compartment, remove the seal-
ing lm, and insert a new pod.
Cancelling the tea
/
18 19
preparation process
– Press and hold the On/O
button
during the brewing process.
The liquid contained in the brewing
container at the time when the pro-
cess is stopped is released into the
/ cup situated beneath the outlet.
14 15
Switching o the tea
maker
– Press and hold the On/O button
for approx. 3 seconds.
The tea maker switches into stand-
by mode. After two minutes, the tea
maker automatically switches into
standby mode if you do not press
any buttons.
16
for approx. 3 seconds
9
PAGE 31
EN
9