Internal Connectors - Sony UPA-PC500 Installationsanleitung

3
Lift the front panel, extending it until the sliding
arm on the right side locks into the notch at the end.
Notes
• The front panel is held in place by magnets and
may require a small tug to release.
• Use both hands to lift open the front panel, and
make sure to lock the sliding arm into the notch at
the end. The front panel is heavy and could cause
serious injury if it fell unexpectedly.
To close the cabinet
1
Lift up the front panel slightly 1, and push inward
on the sliding arm 2 to release it from the notch at
the end.
2
Gently lower the front panel until it clicks into
place.
3

Internal Connectors

No
Yes
A USB ports (4)
B AC power connector
1
C AC power supply switch
2
D IDE port
E USB ports (3)
Note
Use both hands to lower the front panel. The front
panel is heavy and could cause serious injury if it
fell unexpectedly.
Slide the drawer shut, and lock the cabinet lock.
5
4
3
2
678 9 0
wa
w;
ql qk qj qh
Connect to peripheral USB devices. For details, see
"Connecting a Peripheral USB Device" on page 9.
Connects to the specified AC power cord. For
details, see "Connecting the Power Cord" on
page 8.
Turns the AC power supply on and off.
Connects to the combo drive. For details, see
"Replacing Media Drives" on page 10.
The bottom two connect to the media reader. The
top one connects to the USB port at the rear of the
unit. For details, see "Replacing Media Drives" on
page 10.
1
qa qs
qd
qg qf
7
Connections