ASROCK ALiveSATA2-GLAN Handbuch Seite 14

2.5 Onboard Headers and Connectors 2.5 Onboard Headers and Connectors 2.5 Onboard Headers and Connectors
2.5 Onboard Headers and Connectors 2.5 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper
caps over these headers and connectors. Placing jumper caps over the
headers and connectors will cause permanent damage of the motherboard!
FDD Connector
(33-pin FLOPPY1)
(see p.2, No. 22)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.2, No. 13)
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATA Connectors (Black)
(SATA1: see p.2, No. 17)
(SATA2: see p.2, No. 15)
Serial ATA II Connectors (Red)
(SATA II_1: see p.2, No. 27)
(SATA II_2: see p.2, No. 21)
1 4 1 4 1 4
1 4 1 4
ASRock ALiveSATA2-GLAN Motherboard
Secondary IDE Connector (Black)
(39-pin IDE2, see p.2, No. 14)
80-conductor ATA 66/100/133 cable
These two Serial ATA (SATA)
connectors are supported by
VIA
SATA2
support SATA data cables for
SATA1
internal storage devices. The
current SATA interface allows
up to 1.5 Gb/s data transfer
rate.
These two Serial ATAII (SATAII)
connectors are supported by
JMicron
interface), support SATA
SA T AII_1 SAT AII_2
data cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
the red-striped side to Pin1
connect the black end
to the IDE devices
®
VT8237A southbridge,
® JMB 363 (PCIE x1