SUHNER LSE 18-DH Betriebsanleitung Seite 5

blow through.
Safety Instructions
• Do not exceed max. operating speed of tool
and clamping element.
• Observe accurate mounting of insert tools.
• Observe mounting instructions for Mounted
Stones!
• Run tool for a couple of seconds under no
load, replace vibrating insert tools at once,
protect mounted points from knocks and gre-
ase.
• Secure work, use clamps or a vise to hold
work.
• The grinder operator shall wear safety gog-
gles or face shield at all times when the grin-
der is in operation.
• If noise level exceeds 85 dB(A) at the work
station, operator must use ear protection
(plugs and/or ear mufflers).
For additional safety instructions refer to enclosed
brochure DL 39 220 01.
Operation conditions and instructions
The machine can be turned on and off by turning
the lever. 1. Turn locking lever in direction indicated
by arrow , and 2. Depress valve lever 10.
Grinding/Deburring/Cleaning
• Observe even material removal, avoid chatte-
ring.
• Do not treat any material containing asbestos.
Change of tools/abrasives
• Disconnect air supply before changing tools/
abrasives
• Hold Spindle 4 with wrench 5, mount or dis-
mount collet 6 using wrench 7.
• Check concentricity, use only vibration free
tools and always observe M.OS. (Max. ope-
rating speed). Observe mounting instructions
for Mounted Stones!
Maintenance
• Store tool in a clean, dry place. Check the
idling speed from time to time.
• Even if the tool still gives satisfactory service,
have it checked by a trained mechanic after
300 to 400 operation hours, or at least once a
year. Disassembly motor, clean and replace if
necessary the four vanes.
• Warranty claims can only be considered, if
tool is returned complete.
Accessories
All accessories can be found in the
sive Power Tool catalog.
Subject to change!
Abra-
5