Reverb + Pitch Change (Rev + Pit) - Yamaha ProR3 Bedienungsanleitung

26
Advanced uses (2) – Editing functions –

Reverb + Pitch Change (Rev + Pit)

Key Parameter
MAIN
REV RevTime
REV IniDelay
REV HighRatio
REV LowRatio
REV Diffusion
PIT Pitch 1
PIT Pitch 2
PIT Fine 1
PIT Fine 2
PIT Delay 1
PIT Delay 2
PIT Feedback 1
PIT Feedback 2
PIT Pan 1
PIT Pan 2
FINE
PIT/REV Balance *1
REV Rev Mix *2
REV Reverb Type
REV Density
REV HPF
REV LPF
REV Space Mod
PIT Pitch Balance
PIT Base Key
REV Patch
Common parameters
*1 Only when REV Patch is parallel (Reverb + Pitch)
*2 Only when REV Patch is serial (Reverb → Pitch, Pitch → Reverb)
*3 Hall, Room, Vocal, Plate
*4 Reverb + Pitch, Pitch → Reverb, Reverb → Pitch
*5 Set this parameter when you wish to use note messages from a MIDI keyboard etc. to control the pitch difference
between the input sound and the pitch shifted sound.
The pitch difference between the input sound and the pitch shifted sound will be determined by the pitch difference
between the Base Key specified by this parameter and the note-on message that is received. For example if the Base
Key is set to C4, an incoming note-on message of C3 would shift the pitch down one octave, and an incoming note-
on message of D4 would shift the pitch up a whole step.
* MIDI note number 60 is considered C3.
* The range of the actual pitch change is ±1 octave, so even if the specified pitch difference exceeds 1 octave, the
resulting pitch change will stay within this range.
* If Base Key is set OFF, MIDI note-on messages will not control the pitch.
* When using MIDI note-on messages to control the amount of the pitch shift, the pitch of the last-input note-on
message will set the Pitch parameter.
ProR3 Digital Reverberator
Value
0.3 ~ 99.0s
0.1 ~ 200.0 ms
X0.1 ~ X1.0 Refer to "Reverberation" items on page 18
X0.1 ~ X2.4
0 ~ 10
↓Oct ~ ↑Oct
Shift amount of pitch 1
↓Oct ~ ↑Oct
Shift amount of pitch 2
–100 ~ +100 cent Fine adjustment to shift amount of pitch 1
–100 ~ +100 cent Fine adjustment to shift amount of pitch 2
0.1 ~ 300.0 ms Pitch 1 delay time
0.1 ~ 300.0 ms Pitch 2 delay time
0 ~ 99% Pitch 1 feedback amount
0 ~ 99% Pitch 2 feedback amount
L16 ~ R16 Pitch 1 pan position
L16 ~ R16 Pitch 2 pan position
0/100 ~ 100/0 Level balance of reverb and pitch change
0 ~ 100% Reverb amount
*3 Type of reverb tone
0 ~ 100 Density of reverb
Thru, 40 Hz ~ 1.0 kHz Cutoff frequency of reverb high pass filter
400 Hz ~ 20 kHz, Thru Cutoff frequency of reverb low pass filter
0 ~ 10 Modulation level of reverb
0 ~ 100% Balance of direct sound and pitch shifted sound
OFF, C1 ~ C6 *5
*4 Selection of effect combination
Refer to "Common parameters" on page 27
Description