Program Parameters 1 (Primary Effects); Reverberation (Reverb) - Yamaha ProR3 Bedienungsanleitung

18
Advanced uses (2) – Editing functions –

Program parameters 1 (Primary effects)

Reverberation (Reverb)

Key Parameter
MAIN
RevTime
IniDelay
HighRatio
LowRatio
Diffusion
FINE
Reverb Type
ER/REV Balance
ER/REV Delay
Liveness
Density
HPF
LPF
Rev2 Time
Rev2 Delay *2
Rev2 Level *2
Mod Freq
Mod Depth
Mod Delay
Common parameters
*1 Small Hall, Large Hall, Vocal plate, Perc.Plate, Spring, Echo Room, Strings, Snare, Reverb Flange
*2 Only when the input mode is either L-Mono, R -Mono, or LR-Mix.
ProR3 Digital Reverberator
Value
Reverb time of primary reverberation (the time required for 60
0.3 ~ 99.0 s
dB of decay at 1 kHz)
0.1 ~ 200.0 ms Delay time until the primary reverb begins
Reverb time of the high frequency components of the reverb;
X0.1 ~ X1.0
relative to RevTime
Reverb time of the low frequency components of the reverb;
X0.1 ~ X2.4
relative to RevTime
0 ~ 10 Spread of the reverb sound
*1 Type of reverb tone
0/100 ~ 100/0 Level balance between early reflections and reverb
Time difference between beginning of early reflections and
0.1 ~ 100.0 ms
beginning of reverb
0 ~ 10 Decay characteristics of early reflections; 0:dead, 10:live
0 ~ 100 Density of the early reflections
Thru, 40 Hz ~ 1.0 kHz Cutoff frequency of the high pass filter
400 Hz ~ 20 kHz, Thru Cutoff frequency of the low pass filter
Decay time of the secondary reverb; relative to primary
X0.1 ~ X10.0
reverb
Time difference between primary reverb and secondary
0.0 ~ 100.0 ms
reverb
0 ~ 100% Level of secondary reverb; relative to primary reverb
0.05 ~ 40.00 Hz Frequency of reverb modulation
0 ~ 100% Depth of reverb modulation
Shorter values produce modulation in the high range, longer
0.1 ~ 30 ms
values in the low range.
Refer to "Common parameters" on page 27
Description