1. n
1.1 General notes on safety
This operation manual is applicable for the machine LGS
30.
The machine may only be handled by personnel
who are qualified.
1.2 Use of the machine for purposes for
which it is intended
The machine is designed for marking/chisel of metal,
wood, plastic and the like.
1.3 Incorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 EC declaration of conformity
Translations of the «EG-Koformitätserklärung (Original)».
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
07/2019. M. Voyame/Managing Division manager
2. c
2.1 Prior to taking the machine into service
Use oiled compressed air (see also air
quality under section 2.3). Observe nation-
al regulations.
2.1.1 Fitting of hose coupling
Fitting of hose coupling inside diameter min. 4.5mm
(available as optional accessory, item no. 90805400).
16
s
otes on
aFety
ommIssIonIng
2.2 Taking the machine into service
2.2.1 Turn on/Turn off
Switch on the tool by turning in the direction of the arrow
to the stop. Turn back to switch off the tool.
Before cutting off the compressed air supply, al-
ways set the machine to the «OFF» position so
that the tool cannot be reactivated inadvertently.
2.3 Rating data
Pressure
Air consumption
Frequency storke
Sound pressure level EN ISO 15744 67dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
2.4 Operating conditions
Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3.
handlIng
3.1 Tools
Use only clean tools!
3.1.1 Changing/Fitting the tool
Loosen retainer with key.
max. 6.3bar
0.03m
/min
3
30000min
-1
3.7m/s
, K=0.9m/s
2
2
3/4/4
0.150kg
/ o
PeratIon