OHAUS ISLD04HDG Bedienungsanleitung Seite 8

i m S
ncubating icroPlate haker
The Incubating Microplate Shaker is designed to hold two (2) or four (4) microplates, or two (2) Micro-Tube Racks.
1. Place two (2) microplates or deep well blocks diagonally on the tray, or place four (4) microplates or deep well blocks on the tray. The plates/blocks do not have to be filled.
2. Place the corner of the plate/block under the spring located at each corner of the tray.
3. Slide plate/block into place. You are ready to use.
2.
i m S
ncubating icroPlate haker
(2) microplates
NOTE: The tray on the Incubating Microplate Shaker is not designed to hold flask clamps.
S -u
et P
3.
t c
ray onfigurationS
(4) microplates
4.
(2) Micro-Tube Racks
EN
7