OHAUS ISLD04HDG Bedienungsanleitung Seite 3

i
nStallation
Upon receiving the Ohaus Incubating Light Duty/Microplate Shaker, check to ensure
that no damage has occurred during shipment. It is important that any damage that
occurred in transport is detected at the time of unpacking. If you do find such damage
the carrier must be notified immediately.
After unpacking, place the Incubating Light Duty/Microplate Shaker on a level bench
or table, away from explosive vapors. Secure to an immovable work surface by
pressing down on the four (4) corners of the unit, creating a strong suction to the work
surface (DO NOT place on a bench mat). Ensure that the surface on which the unit is
placed will withstand typical heat produced by the unit. Always place the unit on a
sturdy work surface.
The Incubating Light Duty/Microplate Shaker is supplied with a power cord that is
inserted into the IEC connector on the back of the unit first, then it can be plugged into
a properly grounded outlet. The 120V unit plugs into a 120 volt, 50/60 Hz source. The
230V unit plugs into a 230 volt, 50/60 Hz source.
m & S
aintenance ervicing
The Incubating Light Duty/Microplate Shaker is built for long, trouble-free, dependable
service. No lubrication or other technical user maintenance is required. However at
least every three (3) months you should:
• Unplug the unit.
• Remove any accumulated dirt from the base and tray.
• Check all accessible items to make sure they are properly tightened.
The unit should be given the care normally required for any electrical appliance.
Avoid wetting or unnecessary exposure to fumes. Spills should be removed promptly.
DO NOT use a cleaning agent or solvent on the front panel or lid which is abrasive
or harmful to plastics, nor one which is flammable. Always ensure the power is
disconnected from the unit prior to any cleaning. If the unit ever requires service,
contact your Ohaus representative.
e c
nvironmental onDitionS
Operating Conditions: Indoor use only.
Temperature: 5 to 40°C (41 to 104°F)
Humidity: maximum 80% relative humidity, non-condensing
Altitude: 0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity: maximum 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
e D
quiPment iSPoSal
This equipment must not be disposed of with unsorted waste. It is your responsibility
to correctly dispose of the equipment at life-cycle-end by handing it over
to an authorized facility for separate collection and recycling. It is also
your responsibility to decontaminate the equipment in case of biological,
chemical and/or radiological contamination, so as to protect the persons
involved in the disposal and recycling of the equipment from health
hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure that
your equipment is recycled in a manner that protects human health.
EN
2