Cognex DS900 Serie Handbuch Seite 2

Regulations/Conformity: DS900 Series
Note: For the most up-to-date CE declaration and regulatory conformity
information, please refer to the Cognex online support site:
http://www.cognex.com/Support.
DS900 series sensors meet or exceed the requirements of all applicable standards
organizations for safe operation. As with any electrical equipment, however, the best
way to ensure safe operation is to operate them according to the agency guidelines
that follow. Please read these guidelines carefully before using your device.
Regulator
USA
Canada
European Community
Australia
Japan
Safety and Regulatory
CFR 47 FCC Part 15 (b) Class A FDA/CDRH Laser Notice No. 50
ICES-003 Issue 4 Class A
EN 55022:2006/A1:2007 Class A
EN 61000-6-2:2005
C-TICK, AS/NZS CISPR 22 / EN 55022 for Class A Equipment
J55022, Class A
DS910B: Regulatory Model 1AA2
DS925B: Regulatory Model 1AA2
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at personal expense.
1
Specification