Cognex DS900 Serie Handbuch Seite 16

Warnings and Notices: DS900 and DS1000 Series
Sensors
Cognex provides the following warnings and notices:
Do not stare into the beam.
l
Do not view directly with optical instruments (magnifiers).
l
Do not place optical components (mirrors) into the beam.
l
Design test fixtures in such a way that unintentional viewing of the beam is
l
prevented.
Switch off the laser when not in use.
l
Avoid the use of highly reflective materials. If you cannot, try to angle the
l
part so unintentional viewing of the reflection is prevented.
Terminate (block) unused beams.
l
Keep the laser plane horizontal or pointing downwards.
l
Report any issues that may have an impact on laser safety to your
l
supervisor or Laser Safety Officer.
There is no scheduled maintenance necessary to keep the product in
l
compliance.
Under no circumstances should you operate the sensor if it is defective or
l
the seal damaged. Cognex Corporation cannot be held responsible for any
harm caused by operating a faulty unit.
Under no circumstances should you modify in any way the sensor or its
l
housing.
Use of controls or adjustments or performance of procedures other than
l
those specified herein may result in hazardous radiation exposure.
15