FOXY R-12B Bedienungsanleitung Seite 4

8. Motor Rotation: Clockwise / Counterclockwise
In most cases motor rotation is usually reversed by swapping two motor wires. However, in cases where
the motor cables have been directly soldered the ESC cables, motor rotation can be reversed by chang-
ing the value of setting on the ESC.
9. Soft acceleration start-up
(1)...(3) Low (10%-15%-20%): Sets ESC soft acceleration start up for the motors which needs low start
up current.
(4)...(6) Mid (25%-30%-35%): Sets ESC soft acceleration start up for the motors which needs mid
start up current.
(7)...(9) High (40%-45%-50%): Sets ESC soft acceleration start up for the motors which needs high
start up current.
10. Low Voltage Cutoff Type: Reduce Power / Cut off Power
(1) Reduce Power – ESC reduces motor power when the preset Low Voltage Protection Threshold
value is reached (recommended).
(2) Cut Off Power – ESC instantly cuts motor power when the preset Low Voltage Protection Threshold
value is reached.
PROGRAMMING THE FOXY ESC WITH YOUR TRANSMITTER
1. Entering the programming mode
1) Switch your Transmitter ON and set the throttle stick to its maximum position.
2).Connect the battery pack to the ESC
3) Wait for about 2 seconds until you hear four sets of two short beeps (●● ●● ●● ●●) confirming that
the ESC has now entered the programming mode.
2. Selecting the programmable function
The Programming Mode is organized in a closed loop; each programmable function is announced by
an audible tone emitted for four times. You will hear 10 series of tones in a loop (refer to the following
table). When the tone for the desired programmable function sounds, move the throttle stick down to
its minimum position. The motor will emit an accord confirming the set-up of the desired programmable
function has been entered.
1 Bip-
2 Bip-Bip-
3 Bip-Bip-Bip-
4 Bip-Bip-Bip-Bip-
5 Beep-----
6 Beep-----Bip-
7 Beep-----Bip-Bip-
8 Beep-----Bip-Bip-Bip-
9 Beep-----Bip-Bip-Bip-Bip-
10 Beep-----Beep-----
3. Selecting the desired value of a programmable function
Now the motor emitts tones signalling the programmable function values - sequentially; each value four
times. Once the desired value of the programmable item is reached set the throttle stick to its maximum
position. The motor will emit an accord confirming the new setting has been stored.
Brake (1 short tone)
Battery Type (2 short tone)
Cut Off Voltage Threshold (3 short tone)
Restore Factory Setup Defaults (4 short tone)
Motor Timing (1 long tone)
SBEC Voltage Output (1 long tone 1 short tone)
Governor Mode (1 long tone 2 short tone)
Motor Rotation (1 long tone 3 short tone)
Soft Acceleration Start Up (1 long tone 4 short tone)
Low Voltage Cutoff Type (2 long tone)