Protection Features; Filling The Water Tank - Klarstein Townhouse Bedienungsanleitung

PROTECTION FEATURES

Low water alarm
• If the pump has been running for 45 seconds after switching on and the unit then
detects that there is continuously insufficient water in the water tank for more than 5
seconds, the pump will stop and the unit will sound an alarm for 10 seconds.
• If the cooling/humidifying mode button is pressed three times within 3 seconds of
being switched on and there is insufficient water in the water tank, the unit emits a
warning tone.
• If the cooling/humidifying mode button is pressed repeatedly and there is
insufficient water in the water tank for more than 5 seconds, the unit will sound a
warning tone.
• If you press the OFF button, the low water alarm is deactivated.
Auto power off
If the instrument runs continuously for 15 hours and no button is pressed during this time,
the instrument is automatically switched off. If you want to deactivate the automatic
switch-off, press the „Cooling" and „Wind speed" buttons for three seconds. You will
then hear a beep and the automatic power-off function has been deactivated.

FILLING THE WATER TANK

If you want to use the cooling and humidifying function, first fill the water tank with
water. Before filling the water tank with water, it is necessary to first open the button on
the water tank fuse, carefully pull out the water tank and slowly fill the water tank with
water (see illustrations below). After filling in the water, it is imperative to return the water
tank to its original position in the appliance and close the tank fuse again.
EN
29