Powering Up The Pen Tablet - Fujitsu Stylistic 3400 Benutzerhandbuch

Powering Up the Pen Tablet

Follow the procedure below to start the Stylistic 3400 pen tablet. Before you begin,
confirm that the system is in the Off state. To do so, observe the Status display. If the
Power icon is not visible in the Status display, the system is in the Off state or in
Save-to-Disk mode and it is safe to perform this procedure. If the Power icon is
visible (either blinking or on continuously), do not perform this procedure. See
"System States" earlier in this chapter for details on operational modes represented
by the Power icon.
1. Press the Suspend/Resume button to start the system.
2. Ensure that the battery pack in your pen tablet is sufficiently charged, or connect
an external power source such as the AC adapter or auto adapter to your pen
tablet. See "Status Display" in Chapter 1 to determine the percentage of charge
represented by the Battery Gauge icon in the Status display.
After performing system initialization, the system starts the operating system
installed on the hard disk drive. Once the operating system is running, you can use
the system.
Powering Up the Pen Tablet
2
17