Measurements; Predictive Measurement - AND UT-201BLE-A Bedienungsanleitung

Predictive Measurement

1. Press the
When the last measurement is stored,
it is displayed approximately two
seconds.
2. Wait until " " is displayed.
3. Put the temperature sensor on the
mouth floor (under the tongue, at the
root of the tongue and at the side of
the lingual frenulum).
Close the mouth gently.
4. keep the sensor position during
measurement for approximately
30 seconds.
5. The count down indicator is
displayed.
The predictive measurement
mark blinks and rotates.
6. The result is displayed for
approximately 15 seconds, the
predictive measurement mark lights,
the LED of the
and buzzer sounds when the
predictive measurement finishes.
7. Select an operation.
Press the
Keep the sensor position to use the equilibrium
measurement. Proceed to next page.

Measurements

switch.
switch blinks
switch to turn off the thermometer.
English 13
Turn on the device.
Last data
Ready
Sensor position
Measurement start
Count down indicator
Predictive
measurement mark
The result
Mark lights
To next page if the equilibrium
measurement is used.