How To Fill The Salt; Adjusting Salt Consumption - Haier DW9-TFE1 Serie Bedienungsanleitung

How to fill the salt

Salt
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits
will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime
and minerals from the water.
Loading the salt into the container
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
When the low salt indicator "I" lights, you must fill the salt(DW9-
TFE2/TFE3 series).
Remove the lower rack and then unscrew and remove the cap
from the salt container;
If you are filling the container for the first time, fill it with water;
Place the end of the funnel (supplied) into the hole and introduce
about 2 kg of salt. It is normal for a small amount of water to
come out of the salt container.
Carefully screw the cap back on.
Important
To prevent the formation of rust, load the salt just before beginning a wash cycle.

Adjusting salt consumption

The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of
the water used. This is intended to optimize and customize the level of salt consumption so that it re-
mains at a minimum.
To adjust salt consumption, proceed as follows:
Unscrew the cap from the salt container;
There is a ring on the container with an arrow on it (see figure to
the side).
If necessary, rotate the ring in an anticlockwise direction from the
"-" setting towards the "+" sign, based on the hardness of the
water being used.
It is recommended that adjustments be made in accordance with the following table:
ºdH
0J10
NMJOR
ORJRM
The default setting of the water softening system is -. - If using multi-functional tablets fill the salt
dispenser and set the adjuster to -; if the hardness of the water is greater than 60ºfH, set it to +.
10
10
Hardness of the water
ºfH ºmmol/l
MJNT MJNIT
NUJQQ NIUJQIQ
QRJUV QIRJUIV
[RM [UV [UIV
H
I
Selector
Salt
knob
c o n s u m p t i o n
position
(Grams/cycle)
L M
=?J? OM
QM
jba
?H? SM
EN
Autonomy
(cycles/2kg)
L
SM
QM
OR