Neurotech Kneehab XP Multipath Gebrauchsanweisung Seite 15

English
Notes:
• When connected to a Left garment the unit will display "L" for 3 seconds at start up.
• When connected to a Right garment the unit will display "r" for 3 seconds at start up.
Please check that your unit displays the correct code for the garment to which it's connected.
If the unit does not display the expected code, please contact the neurotech
Step 3 – Begin treatment
Begin increasing the intensity (Fig. g). This starts the treatment session and the timer will begin to count
down. As you increase the left or right intensity button you will feel the stimulation increasing on the
corresponding side of your leg. You will also see the intensity level for that side increasing on the unit's
display. Increase the intensity on both sides of your leg until you feel a firm, comfortable contraction of
the quadriceps. The intensity level ranges from 0 - 99.
Important Notes:
• Typically, you should increase the intensity to the inside of your leg first and to optimise contractions, the
intensity level for the inner thigh should be set at a higher level than the outer thigh. As you become
more experienced using Kneehab
• The treatment is delivered in contraction and relaxation cycles. See your Programme Information Card
for more details.
• Changing the intensity at any time will trigger the start of a contraction cycle.
Step 4 – Finishing Treatment & Storage
The treatment session is completed when the counter reaches zero. The unit will beep to indicate this. Switch the unit off by
pressing the On/ Off button for 3 seconds. Should you forget to do this, the unit will switch off automatically after 20 seconds
anyway.
Disconnect the unit from the garment by pressing the buttons on either side of the connector and pulling the two sections apart
(Fig. h).
Remove the garment by carefully peeling the electrodes off your leg. Ensure that the electrodes remain attached to the
garment. Place the garment on a flat surface with the electrodes facing upward and replace the liners on the black side of
each one. If the electrodes have lifted from the garment, press the edges back into position.
Close the straps on the garment, ensuring that the electrodes all remain flat. Store the garment, with the electrodes still attached,
on a flat surface in a cool dry place.
XP, you will quickly find the levels which suit you best.
®
office.
®
Fig. f
Fig. g
Fig. h
15