auna DisGo Box 100 Bedienungsanleitung Seite 23

Switch the POWER switch on the rear to the AC position when using the AC
mains cord, switch to DC position when using an AC/DC power adapter.
Switch to OFF to turn off. Use the POWER/STANDBY button on the device
front panel or on the RC to switch the unit on/off.
Select the desired function mode by pressing MODE repeatedly.
Rotate the Volume knob to adjust the output volume.
Optional: Connect other audio equipment such as PA or another amplifier to
the LINE IN.
Connect microphones to the MIC1 and MIC2 sockets on the front. Turn MIC
VOL down completely beforehand.
Connect guitars or other musical instruments to the GIT IN. Turn the GIT
VOL down completely beforehandr.
Vermehrtes Rauschen kann von einer leeren Batterie herrühren. Ersetzen
Sie mit einer Batterie gleichen Typs und beachten Sie die korrekte Polarität.
Schalten Sie die Mikrofone ab, wenn diese nicht in Benutzung sind.
BT
• Turn on the speaker and set the input to BT (MODE). The unit will beep
to indicate it is ready to be paired with a BT device.
• Enter into the BT connections on your BT device and locate DisGo Box
and connect to this device. At this point you can start playing audio
from your BT device.
• To connect a different device, go to your BT connections on your BT
device and disconnect it from the speaker.
• This speaker doesn't support Hands-free function (call function), when
it is playing music, you get an incoming call from Mobile, the music will
pause. After the call, music will play again.
Radio
Connect the FM antenna to the antenna socket on the rear. Completely
extend for best possible reception.
Use the MODE button to select FM mode. Press PLAY/SCAN for an
automatic FM channel search. Use the CH+/CH- buttons to search the FM
band for the next/previous station.
USB / SD
Connect USB drives or SD cards with music files to the respective sockets
EN
23