Atlas Copco RRC13 serie Produktanweisungen Seite 7

RRC13
RRC 13B
• Install chisel (h), see figure.
RRC 13N
• Install needle set (j; 68), see figure.
Always use complete sets of needles of the same length to ensure the full
working capacity of the machine is reached.
Air quality
• For optimum performance and maximum machine life we recommend the
use of compressed air with a maximum dew point of +10°C. We also rec-
ommend the installation of an Atlas Copco refrigeration-type air dryer.
• Use a separate air filter of type Atlas Copco FIL. This filter removes solid
particles larger than 15 microns and also removes more than 90 % of liquid
water. The filter must be installed as close as possible to the machine/equip-
ment and prior to any other air preparation unit such as REG or DIM (please
see Air Line Accessories in our main catalogue). Blow out the hose before
connecting.
Models which need air lubrication:
• The compressed air must contain a small quantity of oil.
We strongly recommend that you install an Atlas Copco oil-fog lubricator
(DIM). This should be set according to air consumption by the air line tool
according to the following formula:
EN
© Atlas Copco Industrial Technique AB - 9836 978500 00
Safety and operating instructions
7