Installation - Hatco DCS Series Bedienungsanleitung

INSTALLATION

General
WARNING
ELECTRIC SHOCk HAzARD:
• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical receptacle.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F).
FIRE HAzARD:
• Locate unit a minimum of 25 mm (1") from combustible
walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
CAUTION
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
details.
NOTICE
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under the
Hatco warranty. Contact the manufacturer of the
countertop material for application information.
Installing Countertop Mounted Models
(DCS400-1CM)
NOTE: The countertop cannot be thicker than 64 mm (2-1/2").
NOTE: A 6' (1829 mm) power cord is supplied with this unit;
any excess cord should be routed neatly so it does not
hang down.
section for
Countertop
Studs
Clamp Plate
Washers
Nuts
Cutout Diameter
83 mm (3-1/4")