Changing Between Body And Object Mode; Directions For Use - maniquick MQPerfect MQ160 Gebrauchsanleitung

5. Changing between Body and Object Mode

For changing from body to object mode, slide the mode switch
side of the thermometer downwards. For switching back to body mode,
slide the switch up again.

6. Directions for Use

Measuring in Body Mode
• Press the ON/OFF button
segments for 2 seconds.
• The last measurement reading will automatically be shown on the
display for 2 seconds with the «M» icon
When the «°C» or «°F» icon is flashing, a beep sound is heard and
•
the thermometer is ready for measurement
• Aim the thermometer at the center of the forehead with a
distance of no more than 5 cm. If the forehead is covered with
hair, sweat or dirt, please remove the obstacle beforehand to
improve the reading accuracy.
. The display is activated to show all
.
.
•
Press the START button
from the middle of the forehead to the temple area (about 1 cm
at the
above the eyebrow).
• After 3 seconds a long beep will verify the completion of
measurement. If the temple area hasn't been reached before the
long beep is heard, repeat the measurement as described above,
but move the thermometer a little faster.
• Read the recorded temperature from the LCD display.
Measuring in Object Mode
• Follow steps 1-3 above, then aim the thermometer at the center of
the object you want to measure with a distance of no more than 5
cm. Press the START button
verify the completion of measurement.
• Read the recorded temperature from the LCD display.
NOTE:
• Patients and thermometer should stay in steadystate room
condition for at least 30 minutes.
• Don't take a measurement while or immediately after nursing a
baby.
and steadily move the thermometer
. After 3 seconds a long beep will