Cleaning And Disinfecting; Battery Replacement; Technical Specifications - maniquick MQPerfect MQ160 Gebrauchsanleitung

•
Blank display : Check if the battery has been loaded correctly.
Also check polarity (<+> and <->) of the battery.
•
Flat battery indication
symbol shown on the display, the battery should be replaced
immediately.

10. Cleaning and Disinfecting

Use an alcohol swab or cotton tissue moistened with alcohol (70%
Isopropyl) to clean the thermometer casing and the measuring probe.
Ensure that no liquid enters the interior of the thermometer. Never use
abrasive cleaning agents, thinners or benzene for cleaning and never
immerse the instrument in water or other cleaning liquids. Take care not to
scratch the surface of the probe lens and the display.

11. Battery Replacement

This instrument is supplied with one lithium battery, type CR2032. Replace
with a new CR2032 battery when the flashing battery symbol appears on
the display . Remove the battery cover by sliding it in the direction
shown. Remove the battery and replace with a new one
: If the steady battery icon is the only
.

12. Technical Specifications

Type: MQ160 Termometro a Infrarossi
Measurement range:
Body Mode: 34,0 - 42,2 °C (93,2 - 108,0 °F)
Object Mode: 0 - 100,0 °C (32 - 212,0 °F)
Resolution: 0,1 °C / °F
Measurement accuracy:
Laboratory:
±0,2 °C, 36,0 ~ 39,0 °C (±0,4 °F, 96,8 ~ 102,2 °F)
Display: Liquid Crystal Display, 4 digits plus special icons
Acoustic:
• The unit is turned ON and ready for the measurement: 1 short beep
• Complete the measurement: 1 long beep (1 sec.) if the reading is
less than 37.5 °C (99.5 °F), 10 short «beep» sounds, if the reading
is equal to or greater than 37.5 °C (99.5 °F).
• System error or malfunction: 3 short «bi» sounds