maniquick MQPerfect MQ160 Gebrauchsanleitung Seite 55

13. Conditions for Service Under Guarantee
1. SANICO Srl guarantees the absence of faults and mechanical defects
and the completeness of the product when it is sold.
2. Repairs can be done only at Service Centres authorized by SANICO
Srl or by the Authorized Distributor in the country where you have
purchased the appliance.
3. The duration of the period of guarantee on the materials and on
manufacturing and operating defects is 2 years with effect from the
date of sale, subject to all the conditions for the Purchaser shown in
the Instructions for use. The obligations of guarantee do not cover
expendable materials: electrode cups, elastic bands, power supply
cables etc..
4. Complaints relative to the product must be presented directly to the
authorized service centre. The service centre, on the basis of an
agreement with the Vendor, is competent to establish the cause and
nature of the fault. The product will be replaced only if it cannot be
repaired.
5. The owner of the product will provide autonomously for delivering and
collecting the product from the place of the repair under guarantee.
6. The time necessary for the repair under guarantee will be subject to
the degree of seriousness of the fault.
7. The responsibility of SANICO Srl under these conditions of
guarantee will be limited to the amount paid by the Purchaser for
the product in question.
The guarantee on the product will not be applied in the following cases:
• certificate of guarantee filled in incorrectly or falsified; serial number
(if applicable for the specific product) damaged or removed;
• absence of commercial and financial documents (cash receipt,
delivery note) proving the purchase;
• opening or repair of the product by the Purchaser or by an
unauthorized Service Centre;
• defects following failure by the Purchaser to observe the rules for
use, storage and transport of the product shown in the relative
technical and regulations documentation, in which case the
regulations of the aforementioned documentation which have been
infringed must be specified;
• penetration of foreign bodies or liquids inside the product;
• presence on the product of internal or external mechanical defects