Oil+Uv Injection; Edit Oil Data; Edit Uv Data; Edit Gas Filling Data - Sun BLIZZARD QTECH III Gebrauchsanleitung

OIL+UV INJECTION

This operation can be carried out ONLY following a VACUUM operation.
From the MANUAL PROCEDURE, select OIL+UV INJECTION, the following screen is
displayed (only if the hardware for hybrid vehicles is installed in the machine):
Select the STANDARD VEHICLE or HYBRID VEHICLE; the following screen will be displayed:
NOTE: When HYBRID VEHICLE is selected UV is disabled (except HYBRID UV).
NOTE: use arrows to scroll through menu items, then use the keypad to modify procedure
parameters

Edit OIL data

Use arrow to select OIL, then use the keys 0 to 9 to type the volume of oil to be injected.

Edit UV data

Use arrow to select UV*, then use the keys 0 to 9 to type the volume of UV to be injected (type
"0" for no UV injection), can never be more than 10 ml.
* UV is disabled while servicing HYBRID VEHICLE

Edit GAS FILLING data

NOTE: For most systems the quantity of fluid to be refilled is indicated on a plate that is in the
vehicle's engine compartment. If this quantity is not known, look for it in the relevant manuals.
Use arrow to select GAS FILLING, then use the keys 0 to 9 to type the quantity (in grams) of
refrigerant to be charged into the A/C system.
NOTE: If DATABASE is installed, can be used to insert the value of refrigerant into the GAS
FILLING field.
NOTE: if gas filling is lower than 100 grams the following popup warning will be displayed:
INSTRUCTIONS MANUAL
R134a MANUAL PROCEDURE
Standard Vehicle
The use of PAG OIL or DYE
in hybrid cars is dangerous
for the safety of the operator.
Please use the
recommended oil with
specific device
Hybrid Vehicle
R134a MANUAL PROCEDURE
VACUUM TIME
LEAK CHECK
OIL
UV
GAS FILLING
HP LP
-45-
HP+LP