Edit Vacuum Data; Edit Oil Data; Edit Uv Data; Edit Gas Filling Data - Sun BLIZZARD QTECH III Gebrauchsanleitung

Edit VACUUM data:

use the KEYPAD to insert the new value of the VACUUM TIME, press OK to confirm, BACK to
return back.
NOTE: use the VACUUM SETTING to change the duration of the LEACK CHECK.
NOTE: if selected VACUUM TIME is lower 15 minutes the following popup warning will be
displayed:
Press YES to continue, or press NO to go back.

Edit OIL data:

Use arrow to select OIL, then use the keys 0 to 9 to type the volume of oil to be injected, or
select AUTO to reintegrate the same quantity of oil extracted during Recovery.

Edit UV data:

Use arrow to select UV *, then use the keys 0 to 9 to type the volume of UV to be injected (type
"0" for no UV injection)
* UV is disabled while servicing HYBRID VEHICLE

Edit GAS FILLING data:

NOTE: For most systems the quantity of fluid to be refilled is indicated on a plate that is in the
vehicle's engine compartment. If this quantity is not known, look for it in the relevant manuals.
Use arrow to select GAS FILLING, then use the keys 0 to 9 to type the quantity (in grams) of
refrigerant to be charged into the A/C system.
NOTE: If DATABASE is installed, can be used to insert the value of refrigerant into the GAS
FILLING field.
NOTE: if gas filling is lower than 100 grams the following popup warning will be displayed:
INSTRUCTIONS MANUAL
R134a AUTOMATIC PROCEDURE
The selected vacuum time is lower than
15 minutes. The leak check could not be
reliable. Continue?
YES
VACUUM
-34-
NO