Profibus-Dp Expansion Board; Radio/Modem/Plc Expansion Board; Emission (Applies To The Usa); Disposal - Grundfos G100 Montage- Und Betriebsanleitung

7.2 Profibus-DP expansion board

Profibus-DP connection
• Communication chip
• Communication speed
• Connection
Visual indication
Operating status

7.3 Radio/Modem/PLC expansion board

Radio/modem/PLC connection
• Port 1
• Connection
• Communication speed
• Modem type
• Radio type
Visual indication
Operating status

7.4 Emission (applies to the USA)

This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with these instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and found to comply with the limits for a Class A digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with these instructions, may cause harmful interference to radio communica-
tions.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.

8. Disposal

This product or parts of it must be disposed of in an
environmentally sound way:
1. Use the public or private waste collection service.
2. If this is not possible, contact the nearest
Grundfos company or service workshop.
• SPC3.
• 9.6 kbaud to 12 Mbaud.
• RS-485, 9-pin D-sub male connector.
1 light-emitting diode.
• RS-232.
• 9-pin D-sub male connector.
• 1.2 to 19.2 kbaud.
• Zyxel or others.
• Radio modem or protocol-based Niros 2001.
6 light-emitting diodes.
Subject to alterations.
17