Opening Accessory Case; Thread Stand; Changing The Presser Foot - Texi JOY 25 Benutzerhandbuch

EN

OPENING ACCESSORY CASE

To open the accessory case, lift up on the top left side of
the table and pull toward you.

THREAD STAND

The spool pins are used for holding the spool of
thread in order to feed thread to the machine.
To use, pull up the spool pin. Push down for
storage.
(1) Upper thread
(2) Hole
(3) Tangle
NOTE: In case of using the thread which has
tendency to tangle around the spool pin, thread
through the hole of spool pin as shown. The hole
should face to the thread spool.

CHANGING THE PRESSER FOOT

The presser foot must be changed according to the sewing job or stitch you sew.
CAUTION: Turn OFF the power switch before you change the presser foot.
1. Turn the handwheel toward you until the needle is at its highest position.
2.
Raise the presser foot.
3. Remove the presser foot by pushing the presser foot release lever toward you.
4.
Place desired foot with its pin directly under the slot.
5. Lower the presser foot lifter and the presser foot will snap Into place.
60 Texi Joy 25