Special Wash Cycles And Options - Hotpoint Ariston LLD 8M121 Gebrauchsanleitung

Special wash cycles
and Options
Notes:
Optimum performance levels when using the "Fast wash"
and "Express 30'" cycles can be achieved by respecting
the specified number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative
EN testing conditions, please send an email to the following
address:
contact@whirlpool.com
Wash options
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Delayed start option
It is possible to delay the start of the cycle for a period
of time between 1 and 24 hours.
1. After selecting the desired wash cycle and any other options,
press the DELAYED START symbol; the symbol on the display
lights up. Press the DELAYED START symbol to select the time
at which you wish the wash cycle to begin (1 to 24 hours.)
2. Confirm your selection using the Start/Pause symbol; the
countdown will begin. The selected delay period is displayed.
3. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
To deselect it, press and hold the DELAYED START symbol until
the text OFF appears.
The DELAYED START function cannot be set once a wash
cycle has been started.
Short Time option
This option can be used to reduce the duration of
the main wash cycles while maintaining the same
washing and drying performance levels.
Having selected the option, press the Short Time
deselect the option, press the same button again.
(see Table of wash cycles)
, the
button. To
Extra drying option
To improve the dryness level of the crockery, press
the EXTRA DRYING button and the symbol/indicator will light
up. If it is pressed again, the option will be deselected.
A higher temperature during the final rinsing and a longer
drying phase improve the dryness level.
The EXTRA DRYING option increases the duration of
the wash cycle.
Multi-functional tablets option (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding symbol/
indicator will light up. If the button is pressed again, the option
will be deselected.
The "Multi-functional tablets" option results in a longer
wash cycle.
Zone Wash option
This option makes it possible to carry out the wash
cycle in the selected rack only. Select the wash cycle and
then press the ZONE WASH button: the selected rack lights
up and the wash cycle starts in the selected rack only. Press
the button again to deselect the option.
The option is available with the following wash cycles:
Intensive and Normal.
Select the option and the Intensive cycle to start the
ULTRAINTENSIVE ZONE washing. This wash cycle is ideal
for very soiled mixed loads, e.g. pans and saucepans, dishes
with heavy encrustation or difficult-to-clean crockery (grater,
vegetable mill, dirty cutlery). The spraying pressure is stronger
and the washing temperature higher, thus ensuring optimum
handling of stubborn stains.
Select the option and the Normal cycle to start the SAVING
ZONE washing. This function makes it possible to reduce
energy consumption. Cycle duration might change.
Remember to load the crockery in the selected rack only.
*
Only available in selected models.
EN
33