Detergent And Dishwasher Use; Measuring Out The Detergent; Starting The Dishwasher - Hotpoint Ariston LLD 8M121 Gebrauchsanleitung

Detergent and
dishwasher use

Measuring out the detergent

Good washing results also depend on the correct amount of
detergent being used. Exceeding the stated amount does not
result in a more effective wash and increases environmental
pollution.
The amount can be adjusted to the soil level.
In the case of normally soiled items, use approximately either
35g (powder detergent) or 35ml (liquid detergent). If tablets
are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed
with water before being placed in the dishwasher, reduce the
amount of detergent used accordingly.
For good washing results also follow the instructions shown
on the detergent box.
For further questions please ask the detergent producers.
To open the detergent dispenser use the opening device "A".
Introduce the detergent into the dry dispenser "B" only.
Place the amount of detergent for pre-washing directly inside
the tub.
1. When measuring out the detergent refer to the Table of wash
cycles to add the proper quantity. Compartment B comprises a
level showing the maximum quantity of liquid or powder detergent
that can be added to each cycle.
2. Remove detergent residues from the edges of the dispenser
and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until
the closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the wash cycle.
If all-in-one detergents are used, we recommend using the TABS
option, because it adjusts the cycle so that the best washing and
drying results are always achieved.
Only use detergent which has been specifically designed
for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam residues
remaining in the machine after the cycle has ended.
To achieve the best washing and drying results, the combined
use of detergent, rinse aid liquid and refined salt is required.
We recommend using detergents that do not contain
phosphates or chlorine, as these products are harmful
to the environment.

Starting the dishwasher

1. Press the ON-OFF symbol: the display lights up for a few
seconds and the text ON appears.
2. Open the door and pour in a suitable amount of detergent (see
Measuring out the detergent.)
3. Load the racks (see Loading the racks) and shut the door.
4. Press the P symbol to select the wash cycle based on the type
of crockery and its soil level (see Table of wash cycles)
*
5. Select the wash options
options.)
6. Press Start/Pause; the Start indicator light on the display lights
up. The wash cycle number, the indicator lights corresponding
to washing, any selected options and the time remaining until the
end of the cycle appear on the display.
7. Once the wash cycle has ended, its corresponding number
appears on the display along with the text END. Switch off the
appliance using ON/OFF; the text OFF will appear on the display.
8. Wait a few minutes before removing the crockery to avoid
getting burnt. Unload the racks, beginning with the lower level.
The machine will temporarily switch off automatically
during certain extended periods of inactivity in order to
minimise electricity consumption.
*
AUTO WASH CYCLES
equipped with a special sensor which can be used to assess the
level of soiling and automatically select the most efficient and
economic wash cycle accordingly. The duration of the auto wash
cycles may vary due to the operation of the sensor.
If the crockery is only lightly soiled or has been rinsed
with water before being placed in the dishwasher, reduce the
amount of detergent used accordingly.
Changing a wash cycle in progress
If a mistake was made during the wash cycle selection process,
it is possible to change the cycle, provided that it has only just
begun. To change the wash cycle, switch off the machine by
pressing and holding down ON/OFF/Reset; the text 3-2-1 OFF
will appear on the display. Switch the machine back on using ON/
OFF; and select the wash cycle and any desired options again.
Adding extra crockery
Press Start/Pause: the Pause symbol lights up. Open the door,
taking care to avoid the escaping steam, and place the crockery
inside the appliance. Press Start/Pause again: the Start symbol
lights up and the cycle is resumed.
Press Start/Pause to pause the machine; the wash cycle is
stopped temporarily.
At this stage the wash cycle cannot be changed.
Accidental interruptions
If the door is opened during the wash cycle or there is a power
cut, the cycle stops. It starts again from the point at which it
was interrupted once the door has been shut or the electricity
supply restored.
*
Only available in selected models.
(see Special wash cycles and
: this model of dishwasher is
EN
31