Vemer ADR Serie ADR-R-out Bedienungsanleitung Seite 39

• Press the "up" ( ) or "down" ( ) keys to select the value for which the relay
is to intervene.
The values that can be selected are as follows, in order: voltage, current, active
power, apparent power, reactive power, cos w, mean active power, mean apparent
power, mean reactive power, active energy and concatenated voltage
• Press "pK" to select the phase (where possible)
The absence of the phase symbol at the centre of the display indicates
the system value
• Press "T" to confirm the value set
• Press "up" ( ) or "down" ( ) to activate or deactivate "Latching" mode
(maintenance of the alarm condition until a key is pressed), and confirm with "T"
• When "Latching" mode is enabled, the display will go to the measurement
page for the value that has activated the relay (flashing) when the conditions that
generated the alarm are removed
• Select the maximum alarm mode "Hi" or the minimum "Lo" with the
"up" ( ) or "down" ( ) keys and confirm with "T"
➧
➧
➧
- 37 -
User Manual ADR-out Network Analyser
T
T
T