VESTEL VEH11026 Bedienungsanleitung Seite 53

PART 5: CLEANING AND MAINTENANCE OF YOUR OVEN
5.1. CLEANING
Before starting to clean your oven, be sure that all control buttons are off and your appliance
is cooled off. Unplug the appliance.
Do not use cleaning materials containing particles that might scratch the enamelled and
painted parts of your oven. Use cream cleaners or liquid cleaners, which do not contain
particles. As they might ahrm the surfaces, do not use caustic creams, abrasive cleaning
powders, rough wire wool or hard tools. In the event the excess liquids spilling over your
oven should burn, it may cause a damage to the enamel. Immediately clean up the split
liquids. Do not use steam cleaners for cleaning the oven.
Cleaning the interior of the oven
Make sure to unplug the oven before starting to clean it. You will obtain best results if you
clean the oven interior while the oven is slightly warm. Wipe your oven with a soft piece of
cloth dampened with soap water after each use. Then wipe it again, this time with a wetted
cloth, and wipe it dry. A complete cleaning using dry and powder type cleaners. For product
with catalytic enamel frames, the rear and side walls of the inner frame do not require
cleaning. However; depending on usage, it is recommended that you replace them after a
certain period of time.
Clearing of the hob part of the Built-in Oven
For built-in combined products, hobs should be cleaned wiping with a dampened cloth.
Cleaning of the stainless steel parts should be done only with water ans such parts should be
wiped dry with a soft cloth or chamois. Gaps and corners shouldl be cleaned using liquid
detergents or lukewarm vinegar. When cleaning the lids of the models with upper glass lids,
use hot water and rough cloth. Try to clean up without rubbing / scrubbing. You can use liquid
detergents if necessary. Another point to pay attetion to that the glass lid should not be
closed until the job boar is completely cooled off.
Cleaning the vitroceramic glass burner
Unplug the appliance before starting the cleaning.
Wait for the vitroceramic glass to completely cool off before starting the cleaning.
Make sure that the cleaning materials you will use do not contain particals that might
scratch the glass. Use cream detergents or liquis detergents.
The vitroceramic surface shoul be wiped with cold water and wiped dry with a soft piece of
cloth until no cleaning material as is left on the surface.
You can use the cleaning spatula supplied together with your product, for the cleaning of
split foods and residues.
Dessert type of foods should be cleaned immediately after day spill without waiting for the
vitroceramic glass to cool off.
21