Before Installation. Comments; Electrical Connection. Legal Requeriments - AEG COMPETENCE KB68004-5-M Anwenderhandbuch

Installation must only be performed by a fully qualifi ed electrician who must ensure
regulations laid down for installation are observed.

Before Installation. Comments

• To unpack the oven, pull the tab located on the lower part of the box.
• A niche is required in the kitchen unit as per the dimensions shown on the fi gure,
providing a minimum depth of 580 mm. (See fi gures 1 and 2 describing oven fi tting
on the page 106-107).
• To fi t multifunction ovens in their locations, the back part of the unit, must not have
any projections (reinforcements, pipes, sockets, etc).
• The adhesive used for the plastic covering of kitchen furniture must be able to withstand
temperatures up to 85 º C.
Electrical Connection. Legal Requirements
The installer must check that:
• The voltage and cycles of the mains supply correspond to that indicated on the rating
plate.
• The electrical installation can stand the maximum power indicated on the rating
plate.
• The connection diagram is shown in the
following fi gure:
• The electrical connection has adequate earthing in accordance with regulations in
force.
• The connection must be carried out with an omnipolar switch, of an adequate size
for the current drawn. There must be a minimum aperture between contacts of 3 mm
to enable disconnection in the case of emergency, cleaning or bulb exchange.
Under no circumstances must the earth wire pass through this switch.
After connecting the electricity, check that all the electrical parts of the oven are
working.
Installation 21