Synchronising Transmitter / Receiver - Silvercrest STK 16 B2 Montage-, Bedienungs- Und Sicherheitshinweise

Remove the used batteries, if present.
Insert 3 batteries (1.5 V
Note: Ensure correct polarity. This is indicated in the battery
compartment
Close the battery compartment cover
Transmitter:
Remove the name plate from the holder
and remove the rubber cover
11
Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V
marked "+" must face upwards.
Install the rubber cover
back on to the back of the product.
Fasten the holder, screw
of the product & name plate.
The transmitter battery compartment with the holder must be in-
stalled by the screw
stop using the product.

Synchronising transmitter / receiver

The product works on 434 MHz which is a quite common frequency.
To ensure that the function gets no influenced be doorbells in the
neighborhood, the transmitter and the receiver hence have to be syn-
chronized in regard of the encryption. Every transmitter is working
with a different encryption of the signal.
(direct current), type AA).
.
8
(direct current), type CR 2032). The side
, close the holder
16
of the transmitter back on to the back
15
while in use. If the holder is damaged,
15
.
6
by pressing the lock
12
(see fig. C1).
16
of the transmitter
12
GB/IE/NI 13