Description And Assembly - Columbus ST 12 Handbuch Zur Bedienung Und Wartung

GB

DESCRIPTION AND ASSEMBLY

A - Vacuum head
B - Switch
C - Polyester fi lter to set into the tank
D - Hooks for tightening of vacuum head to tank
E - Tank
F - Rolling wheels
G - Paper bag to fi t directly on the suction inlet. Its use
does not exclude the employ of polyester fi lter that
has to be aniway used
H - Suction inlet
I - Flat lance
L - Small brush
M - Aspirmatic double use brush
N - Tube
O - Flexible hose
P - Round brush
Q - Wand
ATTENTION: In order to keep in good effi ciency the machine it
is useful to clean the polyester fi lter after each utilization.
INDICATIONS TO BE SCRUPULOUSLY ADHERED TO
• This apparatus is not to be used by people (children included) with
reduced physical, sensorial or mental capacities or without any
experience and knowledge, unless they did not receive instructions
relative to the use of the apparatus and are controlled by a person
responsible for their safety.
• Children should be controlled so that they didn't play with the
apparatus.
• The packaging components could constitute potential dangers (as
for example plastic bags): they must be kept away from children' s
reach and from other people not conscious of their actions.
• Any different use from that indicated in this manual could constitute
a danger, therefore, it must be avoided.
• Every part of the apparatus must be correctly assembled before
using it. Verify, furthermore, that the fi ltering elements (as for
example paper bag, fi lter cartridge, etc.) have been correctly and
effi ciently assembled.
• Ensure that the socket conforms to the apparatus' plug.
• Ensure that the voltage indicated on the motor block corresponds
with the power that is intended to connect the apparatus to.
• When the device is in operation do not position the suction nozzle
near the delicate parts of people or animals' bodies – such as the
eyes, mouth, ears, etc
• ATTENTION: this apparatus can be used for suction dry only, and
it cannot be stored in the open or under damp conditions.
• ATTENTION: if the apparatus is fi tted with a supplementary plug, do
not exceed the power reported on the plug. Non-compliance with
this norm could cause fi res and damages even lethal to the user.
• ATTENTION this apparatus is not suited to pick up dangerous
dust.
• ATTENTION: do not suck infl ammable substances (ashes from
fi re-place), explosive, toxics or dangerous to the health.
• ATTENTION: the apparatus is not suitable for areas protected
against electrostatic discharges.
NOISE LEVEL: Values measured according to EN 60704 - 1 (1996) / EN 60704 -2 - 1 (2000) rules. Measurement A for the sound pressure
level of the machine is ≤ 69 dB (A) Under unfavourable feed conditions, the appliance may cause temporary drops in voltage.
Do not dispose of power tools into household waste! According to the European Directive 2002/96/EC on
waste electrical and electronic equipment and its incorporation into national law, power tools that are no
longer suitable for use must be separately collected and sent for recovery in an environmental-friendly manner.
OPERATING INSTRUCTION
- Insert the cloth filter in the tank (Fig. 1)
- Assembly the head on tank and lock it by hooks
(Fig. 2)
- Connect the flexible hose into the inlet
(Fig. 3)
- Connect the wand and the extensions to other side
of flexible hose (Fig. 4)
- Select the most suitable accessory (Fig. 5)
- Connect the plug to power socket then switch on
the equipment (Fig. 6)
- Example of use of flat lance (Fig. 7)
- Example of use of small tool (Fig. 8)
- Example of use of brush on the floor (Fig. 9)
- Example of use of brush on the carpet (Fig. 10)
- Example of use of round brush (Fig. 11)
- If a paper bag is provided, insert it in the tank on
the deflector (Fig. 12)
•. ATTENTION: use only the brushes supplied with the apparatus
or those specifi ed in the instruction manual. Using other brushes
could jeopardize safety.
• ATTENTION: don't leave the apparatus unattended while is in
function.
• ATTENTION: in case tipping over, lift the apparatus before switching
off.
• Do not aspire materials that could damage the fi ltering elements
(such as glass, metal etc.).
• Do not ever pull or lift the apparatus through the electrical
cable.
• Do not immerge the apparatus into water and neither use water
jets to clean it
• Always remove the plug from the current socket before undertaking
any type of intervention on the apparatus or if it is left unattended
or within children or people' s reach not quite conscious of their
own actions.
• Regularly control the feeding cable looking for damages, cracks
or ageing. Substitute the cable before using it further.
• If the feeding cable is damaged it must be substituted by the
manufacturer or by its after sales service or in any case by a
similarly qualifi ed person, thus preventing any possible risk.
• When using extension electric wires ensure that they are lying
on dry surfaces and protected against possible water jets.
• Specialized personnel must always carry out maintenance and
repairs; any damaged part must be substituted with original spare
parts.
• ATTENTION: it is forbidden to carry out changes to the apparatus.
Tampering could cause fi res and damages even lethal to the user
and the forfeiture of the guarantee.
• The manufacturer declines any responsibility for damages caused
to people or things due to non-compliance with these instructions
or if the apparatus is unreasonably used.
5