Herunterladen Inhalt Inhalt Diese Seite drucken

Connections, Operating And Display Elements - Cameo EVOS W7 Bedienungsanleitung

Led wash-beam moving head with single pixel control
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 29

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

POWER IN: 100-240 V AC 50-60 Hz
POWER CONSUMPTION: 900 W · WEIGHT: 19 KG
6
5
NET
7
POWER IN
1
Neutrik powerCON TRUE1 mains input socket. Operating voltage 100–240 V AC/50–60Hz. A suitable mains cable with powerCON TRUE1
plug is included.
2
FUSE
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
DMX IN
3
Male 3-pin and 5-pin XLR sockets for connection to a DMX control device (e.g. DMX console).
4
DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal.
NET
5
RJ45 network connections for connecting to an Art-Net, sACN or KlingNet network and for connecting further Art-Net, sACN or KlingNet-ca-
pable devices to the network. Use CAT-5e or better cables to set up the network.
6
NET STATUS LEDS
Yellow status LED lights up = network connection.
Green status LED flashes = control signal is present.
W-DMX™ ANTENNA
7
The antenna for control via W-DMX™ remains in the holder (= operating position) during operation.
EVOS
W7
®
LC DISPLAY
8
The illuminated LCD display shows the currently activated mode (main display), the menu items in the selection menu and the numerical
value or operating mode in certain menu items. If there is no input for approx. one minute, the display automatically returns to the main
display. Note on the main display in operating modes with external control: As soon as the control signal is interrupted, the characters in the
display begin to flash. When there is a control signal again, the flashing stops.
The battery-powered display can be activated, even if the device is not connected to the mains. To do this, press the encoder for approx-
imately 5 seconds. You can now access device information and change and save system settings without mains connection. The external
control of the spotlight is not activated in this case. For this reason, the display shows that there is no DMX signal even if a DMX signal is
available at the device.
9
ROTARY-PUSH ENCODER
Rotary-push encoder for navigating in the editing menu and for adjusting system settings and changing values in the corresponding menu
items. Starting from the main display, press the encoder to enter the main menu. Select the individual menu items in the main menu (Con-
trol, Settings, Info, etc.) and in the sub-menus by turning the encoder and confirm the selection by pressing the encoder. Change the value
or status in a menu item by turning the encoder and confirm the change by pressing the encoder.
3
4
5
DMX IN / OUT
8
362
FUSE
T10AL / 250 V
3
4
2
DMX IN / OUT
9
POWER IN
1
5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Clew7

Inhaltsverzeichnis