Werbung
Handling Wartung Pflege der Tür
Wood preservation treatment of the door:
All parts of the door must always be wood preservation-treated. Those parts of
the wood which will no longer be accessible after assembly is complete should be
fully treated before assembly.
Treat the product with blue sealer, and then give it a double protective coating of
an open-pore wood varnish. Recoat with a new protective coating at the latest
every two years.
Please note that with the doors, if unsuitable coating material is used then the
sheets of material used can take on a different colouring to the doors.
For coloured and pressure-impregnated houses only the natural wood points
(saw-cuts) and parts must be post-treated.
An even colour for the interior can be achieved with a single over painting.
To do this use an acrylic-resin based, open-pore water dispersion varnish. Our
products have the following colour numbers:
elfenbein
RAL
friesenblau
Sikkens
kastanienrot
Sikkens
tannengrün
Sikkens
eiche gold
entspricht
Damaged parts should be repaired immediately in order to ensure a long lifetime
of your product. To do this, lightly sand the damaged part and recoat it with
colour.
Ask your colour specialist for suitable varnishes.
In order to ensure a longer lifetime for the door and to increase the
weatherproofing against driving rain, the wood/window interface ban be sealed
using a suitable sealing compound.
If these protective measures have not been properly carried out then the
results can include deformations, blueness, fungal attack on the doors and
frames and loss of guarantee.
Deformation of the door:
Wood reacts to the effects of the environment. Weathering can lead to swelling
and shrinking of the wood. This can lead to changes in dimensions and mild
deformations. In order to make sure that the door continues to shut properly,
depending on the weather conditions the door may have to be realigned by
screwing in/out the hinges.
A deformation of the door can be accepted provided that the working of the
door can be maintained by the methods for adjusting it described here.
No claim against guarantee can be made for damage which is the result of the
use of force.
1015
RO.30.30
CO.40.20
LO.20.20
Sadolin
693
Adjusting the door:
The door must be precisely aligned if it is to work efficiently. The door frame must
be installed square and vertical. The door frame should also be installed so that it
has the same width at the top and the bottom.
If the door does not close or a wing of the door is skewed, then this can be
corrected by screwing in/out the screw-on hinges. These hinges can be
unscrewed by up to 5 turns. If you have a double-wing door, then the set wing
must always be secured at the top and bottom using the metal fittings provided
for the purpose.
screw-on hinge
Werbung
