Maintenance - Felisatti DC10,8L2 Originalbetriebsanleitung

If drill stalls, it is usually because it is being
overloaded or improperly used. Release
trigger immediately. Do not click trigger on
and off in an attempt to start a stalled drill.
9. Automatic Spindle Lock
The drill spindle is locked when the switch is not
pressed.
This makes quick and easy changing of the tool
in the drill chuck possibble.
10. Battery Protection
When the battery is overheating due to
continuous operation, in order to protect the
battery performance will automatically shut off the
power.

Maintenance

Always keep tool and air ventage clean for
safe work.
1. Changing tool
Before you change the tool, you must remove
the battery from the body of the electric drill or
set the rotational direction swith in lock position
(neutral position).
Figure 11
1) Mounting the Bit
Pull the lock sleeve forward.
Insert a screw driver bit into the tool
holder to the end and release the lock
sleeve.
2) Removing the bit
Keep the lock sleeve pressed forward
while taking out the bit.
2.Environmental Protection
The tool and its accessories contain much
raw materials and plastics that can be recycled
after their life. Therefore, plastic parts are
indicated with their material types so that they
can be classified and recycled for each
material type.
Do not dispose of the battery with home
garbage or into the fire or river.
3. What to do when the tool does not work normally
For power tool with type Y attachment: if the
replacement of the supple cord is necesary, this
has to be done by the manufactuer or his agent
in order to avod a safety hazard.
It is very dangerous for customers to
troubleshoot or repair the tool for themselves,
Contact the nearest A/S center (sales agency)
and request for a service
The repair shall be requested to the
qualified electric speciailst.
4. Y attachment cord
If the replacement of the supply cord is
necessary. this has to be done by the
manufacturer or his agent in order to avoid a
safety hazard.
25